|
Rota-Tuft-
POWER SCRUB & CLEAN
DRILL BRUSH
DRILL 12.5 CM Diameter ACCESSORY
Use DRILL BRUSH � ANYWHERE, ANYTIME WITH ANY DRILL to clean carpet,
fabrics, upholstery, seats wheels and much much more.
 Forget
putting in elbow grease to clean carpet. The Chemical Guys Drill-Brush
is one of the most versatile brushes ever!
You can use it to
clean carpet, upholstery, fabrics, door panels, trunk, wheels and so
much more. Simply let the brash work for you!
The High speed rotation of the drill combined with the highest
quality premium heavy duty brush lifts and quality brushes easily
extracts spots from leather and fabric upholstery and carpet.
These ultra premium heavy duty brushes are available in two varieties to
suit your cleaning needs. Each brush is made of 100 % Polypropylene the
most durable material for brushes.
2 DIFFERENT BRUSHES TO CHOOSE FROM
YELLOW OR
RED FITS ALL DRILLS
100% POLYPROPELYLENE
5 in diameter
 YELLOW
-Standard
Carpet Brush:
This brush is
meant for rigorous scrubbing of durable carpets. The bristles are stiff
enough to dislodge old stains and they will hold up better than the Soft
Carpet Brush on heavy duty carpet. You can also use this brush on tile,
grout, and floor pads.
general scrubbing and cleaning, all carpets, door panels rv's home etc.
i.e., boat decks, hulls and wood-work, house siding, decks, porches,
wood window casings and frames, tiles and grout in bathrooms and showers
and floors, etc.
RED-Heavy
Duty for:
The
red brush has very stiff bristles and is
meant for
intense scrubbing of hard surfaces. Use it
in removing heavy grease, grime,
old, loose paint and blisters, aggregate, barnacle stains on boat
hulls, propellers, rudders and shafts, etc.
Instructions:
 
For best results always wash the surface with water and then spray or
apply your cleanser or soap like
Fabric Clean or
Lightning Fast
Stain Extractor. Tilt the rotating brush at approximately 15� from
the vertical. Too much angle results in only a small portion of the
brush being used. Too little angle or flat on the surface lessens the
cleaning results and causes the brush to wobble. Wash off the surface
with water, check for spots that may have been missed and repeat if
necessary.
Safety Tips
Always wear face and body protection. Be sure that the brush's steel
insert shaft is firmly fastened in the drill chuck. Always use a
properly grounded machine. Maximum RPM 3,500.
|
ONE OF THE BEST INVENTIONS EVER 
