Rota-Tuft-
POWER SCRUB & CLEAN
HEAVY DUTY
DRILL BRUSH
DRILL 12.5 CM Diameter ACCESSORY

Use DRILL BRUSH ANYWHERE, ANYTIME WITH ANY DRILL to clean carpet, fabrics, upholstery, seats wheels and much much more.

Forget putting in elbow grease to clean carpet. The Chemical Guys most versatile brushes ever! 

Use it to clean carpet, upholstery, fabrics, door panels, trunk, wheels and so much more. Simply let the brash work for you!

The High speed rotation of the drill combined with the highest quality premium heavy duty brush lifts and quality brushes easily extracts spots from leather and fabric upholstery and carpet. These ultra premium heavy duty brushes are available in two varieties to suit your cleaning needs. Each brush is made of 100 % Polypropylene the most durable material for brushes.

2 DIFFERENT BRUSHES TO CHOOSE FROM
YELLOW OR RED FITS ALL DRILLS
100% POLYPROPELYLENE
5 in diameter

YELLOW - Standard Carpet Brush: This brush is meant for rigorous scrubbing of durable carpets. The bristles are stiff enough to dislodge old stains and they will hold up better than the Soft Carpet Brush on heavy duty carpet. You can also use this brush on tile, grout, and floor pads. general scrubbing and cleaning, all carpets, door panels RV's home etc. i.e., boat decks, hulls and wood-work, house siding, decks, porches, wood window casings and frames, tiles and grout in bathrooms and showers and floors, etc.

RED- Heavy Duty for:  The red brush has very stiff bristles and is meant for intense scrubbing of hard surfaces. Use it in removing heavy grease, grime, old, loose paint and blisters, aggregate, barnacle stains on boat hulls, propellers, rudders and shafts, etc.

Instructions:

For best results always wash the surface with water and then spray or apply your cleanser or soap like Fabric Clean or Lightning Fast Stain Extractor. Tilt the rotating brush at approximately 15 degrees from the vertical. Too much angle results in only a small portion of the brush being used. Too little angle or flat on the surface lessens the cleaning results and causes the brush to wobble. Wash off the surface with water, check for spots that may have been missed and repeat if necessary.

Safety Tips

Always wear face and body protection. Be sure that the brush's steel insert shaft is firmly fastened in the drill chuck. Always use a properly grounded machine. Maximum RPM 3,500.