 |
 |
 |
|
|
Flex XC 3401 VRG 5.5 inch OEM REPLACEMENT BACKING PLATE |
|
|
|
|
|
|
| |
 |
|
OEM FLEX XC 3401 5.5 inch- Genuine factory replacement backing plate.
Manufactured and sold by flex the The Flex XC 3401 VRG 5.5 inch Backing Plate is an authentic OEM factory replacement for the original backing plate.
Designed specifically for the VC 3401 polisher, this backing plate is nothing short of amazing. The unique "gear -driven" design delivers a true dual action motion. The OEM FLEX backing plate is designed to reduce vibration while providing vibration-free even motion and buffing.
|
|
| |
|
|
|
|
| |
| The Flex XC 3401 VRG 5.5 inch Backing Plate is made of durable molded plastic with a urethane pad to dampen vibration and heat. Hook and loop fasteners cover the bottom of the plate from edge to edge. The backing plate is 5.5 inches in diameter. We recommend 6.5 inch pads or 7.5 inch pads. |
|
 |
| |
|
|
 |
|
Changing your flex backing plate is easy:
- Hold down the black locking button on the top of your FLEX to prevent the backing plate from spinning.
- Once locked use a Allen-wrench to loosen the screw and remove it.
- Lift the backing plate up, away from the gears.
- Seat the new backing plate in making use that it is properly lined up with the vertical slot in the backing plate.
- Lightly tighten screw making sure backing plate is properly seated.
- Push down black locking clip again and tighten alan-wrench screw.
| |
|
| |
|
|
|
|
| |
| |
|
|
 |
|
The orbital rotation of this innovative polisher simulates the circular movement of the human hand while polishing. At the same time, the polisher's highly smooth running facilitates a careful, precise finish and even offers what is necessary for hologram-free polishing. That's just what this polisher, with its ergonomically designed knob handle, was made for. The positive drive ensures a uniform movement, even under load, thanks to constant lift. Taken in conjunction with the large stroke length there is also the possibility of removing existing holograms from black finishes. Thanks to the direct orbital drive, very little heat develops on the surface, which is ideally suited to temperature-sensitive finishes. The accelerator trigger switch and speed selection allow for a controlled acceleration to the optimal speed. Note: the machine's orbital movement has been optimally adapted for the special back pad included with it. |
| |
|
BACKING PLATES AVAILABLE in 5.5" and 4" sizes! | |
|
| |
|
|
|
|
 |
|
 |
|
|
|
